TM 11-5820-489-10
TO 31R4-2GRA6-31
e. Installation of Accessories
Handset - For Local or Remote Control,
q
attach the Connector plug of the Handset
into the AUDIO connector (located on the
front panel). Turn clockwise to lock. When
Handset is not in use, attach to storage
area by using hang up clip.
Be careful! When either unit is in use, the existing voltage
at L1 and L2 may be as high as 90 volts. Use extreme caution.
Telephone Lines - Remove about 3/4 inch
q
of insulation from ends of two wires,
leaving the wiring bare. Press and hold
down binding post knobs. Insert end of
one wire to binding post L1 and release.
Connect the other bare wire end to L2.
This is done at Local and Remote Control
Units.
Local Control Unit
Remote Control Unit
