TM 11-5895-463-15
Section Il. ORGANIZATIONAL REPAIR PROCEDURES
(b) Attach the support assembly to the
shelter support bracket; use the hexagonal-
stallation and Removal -
head studs with the lockwashers and flat
a. Blower Kit Installation.
washers.
(c) Install the bracket assembly using
the four hexagonal-head studs, lockwashers,
(a) T u r n t h e A I R C O N D . c i r c u i t
and flat washers.
breaker to OFF (fig. 1-6).
(d) Install the rubber sleeve on the
(b) Turn the air conditioner OFF-
blower assembly exhaust flange and secure
FAN-COOL selector switch to OFF.
with one blower sleeve clamp assembly.
(c) Disconnect t h e air conditioner
(c) Position the blower shock mount on
power cable (fig. 1-10).
the bracket assembly and align with the blower
(d) Remove the 14 sheet metal screws
mounting holes in the bracket assembly.
that secure the air conditioner protective cover.
Remove the protective cover.
(f) Position the blower, motor base
down, on top of the shock mount on the bracket
(e) Remove the four hexagonal head
assembly.
studs that secure the air conditioner to the
(g) Insert the blower shade in the
mounting bracket.
sleeve and align the blower assembly mounting
(f) Lift and slide the air conditioner
holes.
forward, and remove it from the mounting
(h) Secure the Mower to the bracket
bracket.
assembly using the four hexagonal-head studs,
Warning: The weight of the air con-
lockwashers, and flat washers.
ditioner is approximately 200 pounds. Suf-
ficient personnel must be available to remove
Note. The support assembly and bracket as-
the air conditioner.
sembly mounting holes are slotted to permit proper
alignment of the blower assembly.
(g) Remove the 17 hexagonal-head
studs that secure the air conditioner mounting
(i) Secure the rubber sleeve to the
bracket to the shelter. Remove the mounting
blower vent using a second blower sleeve
bracket.
clamp assembly.
(j) Operate the BLOWER 2 switch to
(2) Installation of blower blank panel
OFF (fig. 5-1).
(k) Connect the blower power plug to
(a) Remove the six slot-head, captive
the BLOWER 2 receptacle.
screws that secure the blower blank panel to
(l) Open the exterior blower vent on
the exterior front curbside of the shelter. Re-
front of the blower blank panel.
move the Mower blank panel.
(m) Operate the BLOWER 2 switch on
(b) Place the Mower blank panel in the
ON and check the blower for proper operation.
air conditioner opening.
(5) Removal of blower. To remove the
(c) Align and secure the blower Mank
blower, reverse the procedure given in (4)
panel using the six slot-head, captive screws.
above.
(d) Adjust and t i g h t e n the wing
bracket on each side of the interior of the
blower blank panel.
(1) Insullation of mounting hardware.
(3) Removal of blower blank panel., T o
(a) Unpack the radio kit and check the
remove the blower blank panel, reverse the pro
contents in accordance with the packaging list.
cedure given in (2) above.
(b) Unpack the major radio equipment
(4) Installation of blower (fig. 4-4).
and check in accordance with the procedures
(a) Unpack the blower kit and check
given in applicable technical manuals (appx
the contents in accordance with the packaging
A).
list.
