TM 5-1940-322-10
0049 00
MAINTENANCE PROCEDURES (Contd)
FILLING TRANSMISSION OIL
CAUTION
To avoid bending dipstick, remove and replace dipsticks
slowly. Failure to comply may result in damage to
equipment.
NOTE
Check transmission oil level with engine running.
1.
Open engine compartment hatches WP 0004 00.
2.
Remove transmission oil dipstick (2) from dipstick tube (3).
3.
Remove transmission oil vent/filler cap (1) from transmission (4).
4.
Check that oil is between ADD and FULL marks.
NOTE
If oil level is below add mark, add oil. During filling of
transmission, check oil level on dipstick often to avoid
overfilling.
5. Insert and remove dipstick (2) to check oil level.
WARNING
Engine must be off and transmission must be in neutral
during filling. Failure to comply may result in injury or
death to personnel.
6.
Fill oil level to FULL marks on dipstick (2).
7.
Insert dipstick (2) on dipstick tube (3).
8.
Install transmission oil vent/filler cap (1) on transmission (4).
9.
Close engine compartment hatches WP 0004 00.
0049 00-14
