TM 5-2420-230-10
5-17. SLAVE-STARTING THE IHMEE.
Do not allow vehicles to touch while slave-starting. Failure to comply may result in damage to
equipment.
NOTE
Slave-starting is a two-person task.
(1)
Start another vehicle with a good charging system and battery (refer to other vehicle's Operator's Manual).
(2)
Move other vehicle into position beside IHMEE so NATO slave receptacles on both vehicles are side by side.
(3)
Shut off other vehicle (refer to other vehicle's Operator's Manual).
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry contacts battery terminal, a direct
short may result in instant heating of tools, damage to equipment, and injury or death to personnel.
(4)
Remove caps (1) from NATO slave receptacles (2) on both vehicles.
To avoid equipment damage, ensure all connectors are free of dirt, sand, and debris. Failure to comply
may result in damage to equipment.
(5)
If equipped, remove caps (3) from NATO slave cable connector (4).
(6)
Plug NATO slave cable connector (4) into NATO slave receptacle (2) on other vehicle.