TM 55-1925-283-12&P
0014 00
REPLACE SENSING PROBE
REMOVAL
WARNING
Replace or repair components only after the affected circuit has been secured,
locked out, and tagged out. Performing replacement with the circuit energized
may result in injury.
1. Drain the sump of the fuel filter/water separator (WP 0013 00).
2. Use a multimeter to check for voltage at the sensing probe wiring (figure 5, item 1). If no voltage is present,
continue with this procedure. If voltage is present, ensure that the proper circuit breaker is secure, locked
out, and tagged out (FM 55-502).
3. Remove the nut (figure 5, item 2) and wiring (figure 5, item 1) from the sensing probe (figure 5, item 3).
4. Unscrew the sensing probe (figure 5, item 3) from its mounting boss (figure 5, item 4).
2
3
1
4
Figure 5. Sensing Probe Replacement
0014 00-7
