TM 55-1925-286-13&P
0017 00
INSTALLATION
1. Wrap the male pipe threads of the drain valve piping (figure 2, item 2) with antiseizing tape.
2. Thread the automatic drain valve (figure 2, item 1) securely onto its piping (figure 2, item 2).
3. Route the automatic drain valve's wiring (figure 2, item 3 and figure 1, item 3) through the packing gland
(figure 1, item 4) and into the junction box. Securely tighten the packing gland.
4. Connect the wiring (figure 1, item 3) inside the junction box.
5. Install the junction box cover (figure 1, item 2) and secure it with the four screws (figure 1, item 1).
6. Remove the lockouts and tagouts (FM 55-502).
7. Operate the air system under usual conditions (WP 0005 00).
8. Slowly OPEN the cutoff valve upstream of the automatic drain valve, and check for air leakage.
9. Press the manual override switch (figure 2, item 4). Observe that the valve opens and closes normally.
10. Return the equipment to the desired readiness condition.
END OF WORK PACKAGE
0017 017304 -3lank
0 0- / 0 b
