TM 9-1550-416-14&P
(3) Install engine. (See fig. 3-19) Attach engine to
(4) Install servo/battery module. (See fig. 3-20.)
mounting plate installed in the nose of the fuselage using four
Ensure that the two servos in the module face forward. Install
servo/battery module into cutout in the horizontal fuselage.
self tapping screws. Tighten all screws "wrist tight" (approxi-
mately 20-25 in/lbs). Ensure all screws on engine are tight
Ensure that the module is fully seated in the cutout. Thread a
prior to installation.
rubber band into the holes in the fuselage. Secure the rubber
band with a dowel in each end.
Figure 3-20. Servo/battery module installation.
Figure 3-19. Engine installation.
CAUTION
The servos and the battery are shipped pre-
mounted to a foam mounting plug. This
mounting plug is to be used for installing
these components. Do not remove them from
this mounting plug. It protects the compo-
nents from damage during flight.
3-17
