TM 9-2320-211-10
(a) Remove L-shaped retaining pin (5) at end of frame tube. Pull each base (6) out until
outrigger leg hits stop.
(b) Lower outriggers to vertical position and replace L-shaped retaining pin (5).
(c) Remove jack adjusting bar (7) from stowage and insert in jack adjusting screw hole.
(d) Use jack adjusting bar (7) to turn out adjusting screw until base (6) is in firm contact
with ground.
NOTE
Outriggers are not required when using boom jacks.
(2) Rigging shipper braces.
(a) Center shipper over rear of truck.
(b) Remove retaining pins securing bottom end of shipper braces (2) to shipper bracket
(l).
(c) Allow shipper braces (2) to swing down. Remove T-shaped retaining pins (3) to
extend braces.
(d) Secure bottom end of braces to brace brackets (4) with L-shaped retainer pins.
TA 155228
