TM
9-2320-279-10-2
M984E1 General Operating Procedures (Cont)
(1) Move SWING control lever (1) to CW position to move boom (2)
clockwise.
(2) Move SWING control lever (1) to CCW position to move boom (2)
counterclockwise.
CAUTION
Keep hook block at least 1 ft (30 cm) from end of boom.
If hook block hits end of boom it may damage cable or
hook block and crane will lose power. Wait six seconds
for power to return and check crane for damage.
NOTE
TELESCOPE and HOIST control levers should be
operated at same time.
q Crane movement from one lever may be slower than
other when operating two levers together.
(3) Move TELESCOPE control lever (3) to OUT position to extend boom (2)
and move HOIST control lever (4) to DOWN position to pay out
cable (5).
CAUTION
Do not go over maximum load rating as shown on
RANGE DIAGRAM. Going over load ratings could cause
damage to equipment.
(4) Refer to RANGE DIAGRAM (6) on equipment body (7) to raise boom (2)
to correct angle before connecting to load.
2-99
