TM 9-2320-366-10-2
Table 3-2. Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
e55.
FRONT AND REAR HAZARD LIGHTS DO NOT ILLUMINATE (CONT).
(i)
Position hazard lights switch to off (para 2-27c).
(j)
Position main light switch to OFF (para 2-27c).
Step 1. Check operation of all vehicle lights (para 2-27c).
If either light does not illuminate, notify Unit Maintenance.
Step 2. Check circuit breaker (CB74) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-17a).
(b)
Position main light switch to OFF (para 2-27c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-27c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-27c).
(g)
Install PDP cover (para 3-17b).
(h)
If front and rear turn signals still do not illuminate, notify Unit Maintenance.
LEFT OR RIGHT FRONT TURN SIGNAL DOES NOT ILLUMINATE.
Step 1. Check operation of all vehicle lights (para 2-27c).
If either light does not illuminate, notify Unit Maintenance.
Step 2. Check circuit breaker (CB74) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-17a).
(b)
Position main light switch to OFF (para 2-27c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-27c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-27c).
(g)
Install PDP cover (para 3-17b).
(h)
If left or right front turn signal still does not illuminate, notify Unit Maintenance.
Change 1
