TM 9-2330-203-14P
SECTION II. SERVICE UPON RECEIPT
Page
Paragraph Title
Number
General................................................................................................................................................ 4-2
Preliminary Inspection ...............................................................................................................................
4-4.
GENERAL.
When a new or reconditioned dolly is first received, determined whether it has been properly prepared for service
and is in condition to perform its preliminary inspections and service listed in paragraph 4-5.
4-5. PRELIMINARY INSPECTIONS AND SERVICES.
a. Refer to DD Form 1397 for procedures on unpacking the dolly.
b. Remove any protective materials used on the dolly during shipment
WARNING
Dry claening solvent, P-D-680, is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin , eyes, and
clothes, and DO NOT use near open flames or excessive heat. The solvent's flash point is
100F-138F (38C-59C). If you become dizzy while using cleaning solvent, immediately
get fresh air and medical help. If solvent contacts eyes, immediately wash your eyes and
get medical aid.
clean all exterior surfaces coated with rust preventive compounds. Refer to DD Form 1397
and follow all instructions carefully.
d. Make a complete visual check of the dolly to ensure that there was no damage
during shipment and that all accessories and required publications are present. Check
also to see if equipment has been modified.
e. Perform all Semiannual (S) PMCS as shown in Table 4-1. Correct any
deficiency if authorized by the Maintenance Allocation Chart (MAC) in Appendix B.. If not
authorized, notify your supervisor. Schedule the next PMCS on DD Form 314.
f.
g. Perform a break-in road test of 25 mi (40 km) at a maximum speed of 30 mi/h
(48 km/h).
4-2