TM 9-2330-205-14&P
INSPECTION INSTRUCTIONS - CONTINUED
METAL LINES, FLEXIBLE LINES (HOSES), AND METAL FITTINGS
Inspect metal lines for sharp kinks, cracks, bad bends, or if badly dented.
Inspect flexible lines for fraying, evidence of leakage, or loose metal fittings or connectors.
Inspect gear teeth for wear, chips, or breakage.
Inspect gear shafts for wear or grooving.
BUSHINGS
Inspect bushings for excessive wear, elongation, or grooving.
Section VII. ELECTRICAL SYSTEM
Page
Page
Blackout Stoplight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-17
InterVehicular Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-23
Main Harness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-25
Blackout Stoplight Lamp and Lens . . . . . . . . . . . . 4-16
Composite Light . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-22
Service Taillight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-19
Service Taillight Lamp and Lens . . . . . . . . . . . . . . 4-18
Composite Light Lamp and Lens . . . . . . . . . . . . . . . 4-20
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-16
Wiring Harness Repair . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-27
GENERAL
This section provides instructions for organizational maintenance of the electrical system. Good
contacts are essential to good operation of the electrical system. When replacing a light assembly
make certain that there is no paint on the mating surfaces. If, after performing a maintenance task,
the electrical system does not operate properly, troubleshoot in accordance with the instructions in
the troubleshooting section.
BLACKOUT STOPLIGHT LAMP AND LENS
This task covers:
INITIAL SETUP
Materials/Parts
Tools
Screwdriver, flat-tip
Lamp
Lens