TM 9-2330-205-14&P
HUB AND BRAKEDRUM - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
INSTALLATION CONTINUED
a. Clean and repack in accordance with
Bearing cone (2)
Spindle (1)
26.
TM 9-214.
b. Install.
Using bearing adjustment socket, install.
Adjusting nut (3)
27.
Do not tighten.
WHEEL BEARING ADJUSTMENT
a. Using bearing adjusting socket, tighten
Adjusting nut (3)
28.
until hub and drum (4) just binds.
b. Back off approximately one-eighth turn.
Wheels should not rock and should
turn freely.
NOTE
Repeat step 28 if rocking movement is excessive.
Using bearing adjusting socket, install
Lockwasher (5) and
29.
and tighten nut (6).
locking nut (6)
Using flat-tip screwdriver, install.
Gasket (7), hubcap
Hub and drum (4)
30.
(8), three lock-
washers (9), and
three screws (10)
a. Raise jack (12) so axle (11) clears
Jack (12) and
Axle (11)
31.
jack stand (13)
jack stand (13).
b. Remove jack stand (13).