TM9-2330-207-14
Lead cables along left chassis longitudinal frame rail to crossmember over trunnion tube.
(b)
Secure cables with clips and No. 10 X 3/4 tapping screws.
(c)
Position cables going to right taillights along crossmember over the trunnion tube and secure
(d)
with clips and No. 10 X 3/4 tapping screws.
Then position cables going to right taillights along right longitudinal frame rail and back to
(e)
connector clips near right taillights. Secure with clips and No. 10 X 3/4 tapping screws.
(f)
Cables going to left taillights continue along the left longitudinal frame rail to connector
clips near the left taillights. Secure with clips and No. 10 X 3/4 tapping screws.
Insert cables into connector shells and install grommets and bushings, pull tightly into shells.
(9)
Note numbers of cables and match with similar numbers on taillight cable connector and
position connectors in connector clips.
Position receptacles on front of crossmember. Connect ground cables to rear of front cross-
(h)
member. Secure each receptacle with four 1/4-28NF-2 nuts, 1/4 washers and 1/4-28NF-2 X
7/8 screws.
(2) Body cable receptacles and wiring (M128 and M129 series) (figs. 2-25 and 2-26).
(a) Insert the terminal ends of cables through openings in side of right longitudinal frame rail.
(b) position receptacles in openings and secure each with four No. 10-24NC nuts, No. 10 washers
and No. 10-24NC X 3/4 screws.
(c) Connect ground cables to side of frame rail.
(d) Insert cables into connector shells and install grommets; pull cables tightly into shells. Note
numbers on cables and match with similar numbers on cables at connector clip near back of
intervehicular cable receptacle.
(e) Connect with connectors and position in connector clip.
(3) Clearance light cables (M127 and M127A1) (figs. 2-22 and 4-21).
(a) To install cables for amber right and red right blackout clearance lights, install terminal of
cable No.490A in connector at end of cable No.490. Cable No.490 originates at the receptacle.
(b) Position cable No. 490C along right longitudinal frame rail to red blackout clearance light.
Install terminal in connector shell and couple with mating part on light cable.
(c) To install cables for amber left and red left blackout clearance lights, connect cable No.490B
to connector on cable No. 490. Position the other cable No. 490C along left longitudinal
frame rail to red blackout clearance light. Install terminal in connector shell and couple with
mating part on light cable.
(d) To install cables for amber left and red left service clearance lights, connect cable No. 489
with connector on cable Nos. 489 and 21 of the receptacle. Cable No. 489A is connected to
connector clips near light, and cable No. 489C is positioned along left longitudinal frame rail
to connector clips near red left service clearance light. install terminal in connector and couple
with mating part on light cable.
(e) To install cables for amber right service clearance light, connect connector on cable No. 489B
to connector on cable Nos. 489 and 489A. Position cable No. 489C along right longitudinal
frame rail to red service clearance light. Install terminal in connector shell and couple with
light cable connector part.
NOTE
Make certain that marker numbers on corresponding cables match when
coupling connectors. Make sure cables passing through holes in frame are
protected from wear by a grommet in each hole and that clips and No. 10
X 3/4 tapping screws holding cables to frame, grip cables securely.
4-41