TM 9-2330-213-14&P
4-30. HANDBRAKE CABLE REPLACEMENT (ALL EXCEPT M107A1) (Con't).
5.
Loosen two nuts (11 ) on turnbuckle (12). Remove cotter pin (1 O), flatwasher (9), and clevis pin (20), and
disconnect clevis (19) from handbrake lever (8). Discard cotter pin.
Remove two nuts (15), Iockwashers (16), bolts (13), bracket (14), and handbrake cable (3) from
6.
crossmember (17), Discard Iockwashers.
7.
Remove turnbuckle (12) and two nuts (11 ) from handbrake cable (3) and rod (18).
b. INSTALLATION
Loosely install turnbuckle (12) and two nuts (11) on handbrake cable (3) and rod (18).
1.
2.
Position handbrake cable (3) on trailer. Install handbrake cable and bracket (14) on crossmember (17)
with two bolts (13), new Iockwashers (16), and nuts (15).
Connect clevis (19) to handbrake lever (8) with clevis pin (20), flatwasher (9), and new cotter pin (10).
3.
4.
Insert handbrake cable (3) in backing plate (1).
NOTE
Step S applies only to M103A3.
Tighten two nuts (6) at guide bracket (7) and backing plate (1).
5.
TA505267
4-35
