TM 9-2330-227-14&P
BACKING PLATE AND SPIDER ASSEMBLY, TWO-WHEEL CYLINDER - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
REPAIR OF SPIDER ASSEMBLY - CONTINUED
Put in place.
Sleeve (2)
10. Worm (1)
Using ball-peen hammer, tap in place.
Stud (4), with
11. Spider (3)
Make sure sleeve opening
worm (1), and
lines up with opening in spider
sleeve (2)
for gear.
Put in place.
Ring (5)
12. Spider (3)
and worm (1)
Washer (6)
Using snapring pliers, put in place.
13. Spider (3)
and ring (5)
Put in place making sure gear (7) meshes
14. Spider (3)
Gear (7)
with grooves in worm (1).
and worm (1)
Screw (8) and
a. Put screw (8) in place.
15. Spider (3)
stud (4)
b. Using 3/8-inch socket and ratchet
handle with 3/8-inch drive, turn stud
(4) clockwise until screw (8) is
completely in spider (3).
c. Repeat steps 9 thru 15b for remaining
adjustment assembly.
INSTALLATION
Put in place.
16. Backing plate (9)
Spider (3)
Backing plate (9)
Noting matchmarks, put in place.
17. Spindle (10)
10 screws (11)
Screw in, and tighten using 13/16-inch
18. Spider (3)
and locknuts (12)
socket, 3-inch extension, ratchet handle
and spindle (10)
with 1/2-inch drive, and 7/8-inch box-
end wrench.
4-94