TM 9-2330-227-14&P
BRAKESHOE ASSEMBLIES, ONE-WHEEL CYLINDER OPTION - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
CLEANING - CONTINUED
b. Using compressor and air gun, dry
6. Continued
with low pressure air.
lNSPECTION/REPLACEMENT
WARNING
Worn brake linings could result in injury or death to personnel, When brake linings are
worn to within 0.0625-inch (1.59 mm) of rivets, they must be replaced.
NOTE
For more information on how to inspect parts, go to General Maintenance Instructions
Brakeshoe
a. Look for glazed or loose condition.
7.
linings (1)
b. Using depth gage, measure
lining thickness.
c. If glazed, loose, or worn, notify
Direct Support Maintenance.
All parts
Look for bends, cracks, gouges, breaks
8.
or severe signs of wear.
INSTALLATION
Two retract spring
Put in.
9. Two brakeshoes (2)
pins (3)
Two cotter keys (4)
Put in, and spread using straight jaw
10. Two retract
pliers.
spring pins (3)
Two brakeshoes (2)
Put on, and slide into place.
11. Two anchor pins
Be sure brakeshoes and brake
(5) and brake
guide pins (6)
cylinders (7) line up properly.
Put on using slip-joint pliers and
12. Two anchor
Strap (8) and two
pins (5)
C-washers (9)
ball-peen hammer.
