TM 9-2330-227-14&P
HYDRAULIC TUBES AND FITTINGS - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
INSTALLATION - CONTINUED
Fitting (2) with
Put in place.
31. Connection (1)
gasket (3)
Put in place.
Gasket (4)
32. Fitting (2) and
connection (1)
Fitting (2) and
Screw in, and tighten using 3/4-inch
33. Left top wheel
gasket (4)
box-end wrench.
cylinder (5)
Connection (7)
Screw in, and tighten using 7/16-inch
34. Nut (6)
open-end box and 9/16-inch
open-end wrenches.
Put in place.
Left tube (10)
35. Axle (8) and
two clamps (9)
Gasket (12)
Put in place.
36. Bott (11)
Bolt (11) with
Put in place.
37. Connection (7)
gasket (12)
Gasket (13)
Put in place.
38. Bolt (11) and
connection (7)
NOTE
For the one-wheel cylinder option, bolt (11) screws into the wheel cylinder on the top of
the backing plate.
Bolt (11) with
39. Fitting (2)
Screw in, and tighten using 11/16-inch
gasket (13)
box-end wrench.
Tee (15)
Put on.
40. Stud (14)
Nut (16)
41. Tee (15) and
Screw in, and tighten using 1/2-inch
stud (14)
socket and ratchet handle with 1/2-
inch drive.
Two nuts (17)
42. Tee (15)
Screw in, and tighten using 7/16-inch
open-end box wrench.
Two clamps (9)
43. Axle (8) and
Using ball-peen hammer, tap into place.
left tube (10)
4-112