TM 9-2330-227-14&P
HYDRAULIC TUBES AND FITTINGS
This task covers:
a. Removal (page 4-108)
b. Installation (page 4-111)
INITIAL SETUP
Tools - Continued
Tools
Wrench, open-end box, 7/16-inch
Chisel, cold, hand, 1/2-inch
Wrench, open-end box, 5/8-inch
Handle, ratchet, 1/2-inch drive
Wrench, open-end box, 1/2-inch
Socket, 1/2-inch drive, 1/2-inch
Hammer, hand, ball-peen, 2-lb
Pan, drain
Personnel Required
Wrench, box-end, 11/16-inch
One
Wrench, box-end, 3/4-inch
Wrench, open-end, 9/16-inch
Equipment Condition
Wrench, open-end, 5/8-inch
Air reservoir drained (page 2-13).
ACTION
ITEM
REMARKS
LOCATION
NOTE
Hydraulic tubes and fittings for two-wheel cylinder and one-wheel cylinder options are
removed and installed the same. This task is for two-wheel cylinder brakes; repeat for
the one-wheel cylinder option.
REMOVAL
Nut (2)
a. Place drain pan underneath.
1. Adapter (1)
b. Using 5/8-inch open-end wrench and
1/2-inch open-end box wrench,
unscrew, and take off.
2. M a s t e r
Adapter (1) and
Using 11/16-inch box-end wrench,
gasket (4)
unscrew and take off.
cylinder (3)
Nut (6) and
Using 5/8-inch open-end box wrench,
3. Tee (5)
hose (7)
unscrew and take off.
Two nuts (8)
Using 7/16-inch open-end box wrench,
4.
unscrew and take off.
4-108
