TM 9-2330-235-14&P
4-11.
COMPOSITE LIGHT ASSEMBLY MAINTENANCE.
This Task Covers:
a. Repair
c.
Installation
b. Removal
Initial Setup:
Equipment Conditions:
Materials/Parts:
Intervehicular cable disconnected from towing
Marker tags (Item 14, Appendix E)
Tools/Test Equipment:
General mechanic's tool kit
a.
REPAIR
1. Loosen six captive screws (2) and remove lens (1) from body (9). Inspect preformed packing (3) for damage. If
damaged, remove and discard.
2. Remove lamps (4) from sockets (5).
NOTE
To replace LEDs, perform steps 3 through 5.
3. Insert a small flat-tipped screwdriver into slot inside center hole in LED (11). Firmly push in, turn counterclockwise
slightly, and remove LED.
4. Insert a small flat-tipped screwdriver into slot on left side of LED (10) and remove cover, allowing access to slot in
center hole. Firmly push in with screwdriver in center hole slot, turn counterclockwise slightly, and remove LED.
5. Install LEDs (10 and 11) by snapping into place with hand application.
6. Install lamps (4) in sockets (5).
7. I removed, Install new preformed packing (3) In lens (1).
8. Install lens (1) on body (9) and tighten six captive screws (2).
4-16