TM 9-2330-235-14&P
4-27.
BRAKESHOE REPLACEMENT (M390C).
This Task Covers,
a. Removal
c. Installation
b. Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
Dry cleaning solvent (Item 13, Appendix E)
One cotter pin
Tools/Test Equipment:
General mechanic's tool kit
Common no. 1 shop set
Personnel Required: Two
a.
REMOVAL
WARNING
DO NOT handle brakeshoes, brakedrums, or other brake components unless area has been
properly cleaned. There may be asbestos dust on these components which can be dangerous if
you touch it or breathe it. Wear an approved filter mask and gloves. Never use compressed air or
a dry brush to clean brake components. Dust may be removed using an industrial-type vacuum
cleaner. Clean dust or mud away from brake components with water and a wet, soft brush or
cloth. Failure to follow this warning may result in serious illness or death to personnel.
1. Remove cotter pin (5), straight pin (4), and
disconnect clevis (2) on front end of rod (3) from
handbrake lever (1) Discard cotter pin.
TA505011
4-55