TM 9-2330-247-14&P
BRAKESHOE ASSEMBLY (Con't)
4-32.
ACTION
ITEM
REMARKS
LOCATION
WARNING
DO NOT handle brakeshoes, brakedrums, or other brake components unless area has
been properly cleaned. There may be asbestos dust on these components which can
be dangerous if you touch It or breathe It. Wear an approved filter mask and gloves.
Never use compressed air or a dry brush to clean brake components. Dust may be
removed using an Industrial-type vacuum cleaner. Clean dust or mud away from brake
components with water and a wet, soft brush or cloth. Failure to follow this warning may
result In serious illness or death to personnel.
NOTE
This procedure covers removal, cleaning, Inspection and replacement, and installation
of one pair of brakeshoe assemblies. Repeat for the other pair of brakeshoe
assemblies.
REMOVAL
Brakeshoe lever (3)
Pull up out of slot.
1.
Cable end (12)
Two upper pins (4)
Upper spring (23)
2.
Using brake repair pliers, pull off.
Two slotted
in. flat-tip screwdriver,
3.
a . Using hammer and
washers (1)
tap out slotted washers (1).
b. Pull off washers (2).
and four
washers (2)
4.
Pull off together, then separate.
Brakeshoe lever
(3) and link (22)
Backing plate
Nut (16),
5.
Using
in. socket and ratchet handle with
in.
(9) and
Iockwasher (15),
drive, unscrew and take off.
brakeshoe
washer (14),
assembly (6)
spacer (13),
and screw (11)
6.
Using
in. socket, ratchet handle with in. drive,
Screw (21),
and slip-joint pliers, unscrew and take off.
Iockwasher (20),
washer (19),
Screw (21 ) mounts hydraulic tee to backing
plate (9).
and spacer (18)
Two lower pins (5)
Using brake repair pliers, pull off.
Lower spring (17)
7.
Take off.
Backing plate (9)
Two brakeshoe
8.
assemblies (6)
Two upper pins (4)
Using
in. socket, ratchet handle with in. drive,
Two nuts (8) and
9.
and slip-joint pliers, unscrew and take off.
Iockwashers (7)
4-58
