TM 9-2330 -247-14&P
HANDBRAKE CABLE AND LEVER ASSEMBLY (Con't)
4-30.
ACTION
ITEM
REMARKS
LOCATION
NOTE
Ensure that handbrake lever is released before proceeding.
For trailers equipped with handbrake levers mounted on the
front corners of the trailer you must remove and discard the
following parts from the new handbrake lever before
proceeding with installation:
(a) Bellcrank pivot stud, nuts, and spacer.
(b) Bellcrank pin, washer, and cotter pin.
(c) Bellcrank and bushing.
Line up holes and push clevis pin (22) into place.
Clevis (3) and
Clevis pin (22)
32.
handbrake lever
tongue (5)
Slip into holes in clevis pin (22) and bend overusing
Clevis pin (22)
33.
Cotter pin (4)
slip-joint pliers.
Place in position.
Handbrake lever
Side front
34.
(6)
chassis frame
(11)
Side front
Two screws (20),
35.
Screw in and tighten using
in. socket, ratchet
handle with in. drive, and
in. box-end wrench.
chassis frame
bushings (12),
Iockwashers (9),
(11) and
and nuts (10)
handbrake
lever (6)
Screw in and tighten using
in. socket, ratchet
Screw (21),
36.
bushing (13),
handle with in. drive, and
in. box-end wrench.
Iockwasher (7),
and nut (8)
4-54
