TM 9-2330-247-14&P
RETRACTABLE SUPPORTS
This Task Covers:
Installation
c.
Removal
a.
b. Repair
Initial Setup:
Materials/Parts:
Equipment Conditions:
Tools/Test Equipment:
Personnel Required: Two
Caps, vise, jaw
Drift, brass, in.
Hammer, hand, ball-peen, 3 lb
Pliers, slip-joint
Puller/instalilr, cup
Puller, seal
Punch,
in.
Punch,
in.
Screwdriver, flat-tip, in.
Socket, in. drive,
in.
Trestle, motor vehicle, 10 ton
Vise, machinist's
Wrench, adjustable, 10 in.
Wrench, automotive, adjustable
Wrench, box-end,
in.
Wrench, box-end,
in.
Wrench, torque, 0200 Ib.-ft. range
ACTION
ITEM
REMARKS
LOCATION
NOTE
Both retractable supports are replaced and repaired in the same way. This procedures is
for one; repeat for the other.
REMOVAL
a. Place trestle under front of trailer.
Frame (4)
Safety chain
1.
b. Lower retractable support to park position
plate (1)
c. Raise retractable support tire (2) off ground
Using slip-joint pliers, unbend and pull out.
Cotter pin (9)
Square neck
2.
bolt (11) and
nut (8)