TM 9-2330-285-14&P/TO 36A11-21-10-1
FRONT HARNESS AND JUNCTION BOX
This task covers:
c. Assembly of components
a. Junction box cover removal
d. Junction box cover installation
b. Disassembly of components
(page (4-41)
INITIAL SETUP
Materials/Parts
Tools
Resistors (as required)
Flat-tip screwdriver
Cross-tip screwdriver
Applicable Configurations
7/16-inch open end wrench
318-inch open end wrench
Early models
7/64-inch socket head wrench
NOTE
Perform only the steps in this task that are necessary to do what is needed on your
particular equipment.
ACTION
REMARKS
ITEM
LOCATION
JUNCTION BOX COVER REMOVAL
Take out using cross-tip screwdriver.
Six screws (1)
1 Junction box
Lift cover off as far as wiring will allow it
Cover (2) and
2
to go.
gasket (3)
TA 221671
