TM 9-2330-285-14&P/TO 36A11-21-10-1
PUMP - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
REMOVAL
NOTE
This is a typical procedure for the front or the rear system.
Take off by holding fitting (3) using a
Line (2)
4 Hydraulic pump (1)
5/8-inch open end wrench and unscrewing
nut (4) using another 5/8-inch open end
wrench.
Take off by holding fitting (6) using a
Hose (5)
5
9/16-inch open end wrench and unscrewing
nut (7) using a 5/8-inch open end wrench.
Take out using a 1/2-inch box wrench and
Four screws (9),
6 Axle beam (8) to
a 1/2-inch socket wrench.
four nuts (10) and
hydraulic pump (1)
four washers (11)
Take off of chassis.
Hydraulic pump (1)
7 Axle beam (8)
INSTALLATION
Place in position on chassis.
Hydraulic pump (1)
8 Axle beam (8)
Put in using a 1/2-inch box wrench and a
Four screws (9),
9 Axle beam (8) to
1/2-inch socket wrench.
four nuts (10) and
hydraulic pump (1)
four washers (11)
Put on by holding fitting (3) with a 5/8-
Line (2)
10 Hydraulic pump (1)
inch open end wrench, and screwing on nut
(4) using another 5/8-inch open end wrench.