TM 9-2330-287-14&P
SERVICE UPON RECEIPT OF MATERIEL - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
UNPACKING
DD Form 1397
Read and follow all instructions.
Trailer
1.
Metal straps, ply-
Using strap cutter and nail puller, remove
2.
wood, tape, seals,
all straps, plywood, tape, seals, and
and wrappings
wrappings.
CHECKING UNPACKED EQUIPMENT
WARNING
Drycleaning solvent PD-680 is both toxic and flammable. Avoid prolonged breathing of
vapors and avoid skin contact. Do not use near open flame or excessive heat. Flash-
point of solvent is 138F (59C). Serious illness, injury, or loss of life could result from
improper use.
Coated exterior
Using drycleaning solvent and rags, remove
3.
parts
rust-preventive compound.
Trailer
a. Inspect for any damage during
4.
shipment.
b. Check for modification of equipment.
Equipment packing
Check equipment against packing list for
5.
list
Discrepancies must be reported in
accordance with introduction In
TM 38-750.
PRELIMINARY SERVICING AND ADJUSTMENT OF EQUIPMENT
Perform the operator and organizational preventive maintenance checks and services (PMCS) as
described on pages 2-8 and 4-7.
Lubricate all points as shown In the Lubrication Chart (page 4-3) regardless of interval.
Schedule the next PMCS on DD Form 314, Preventive Maintenance Schedule and Record.
Report all problems on DA Form 2407 If the deficiencies appear to Involve unsatisfactory design.
Perform a break-in road test of 25 miles (40.2 km) at a maximum speed of 50 mph (80 km/h).
