TM 9-2330-287-14&P
CLEANING INSTRUCTIONS - CONTINUED
ELECTRICAL CABLES, FLEXIBLE HOSES, AND OIL SEALS
CAUTION
Washing electrical cables and flexible hoses with drycleaning solvents or mineral spirits
will cause serious damage or can possibly destroy the material.
Wash electrical cables and flexible hoses with soap and water solution, and wipe dry.
Oil seals are normally damaged during removal and must be replaced. Cleaning will not be
necessary.
Refer to TM 9-214 for instructions and procedures covering care and maintenance of antifriction
INSPECTION INSTRUCTIONS
All components and parts must be carefully inspected to determine if they are serviceable for reuse,
can be repaired, or must be scrapped.
DRILLED AND THREADED HOLES AND SURFACES
Inspect for wear, distortion, cracks, and any other damages in or around drilled and threaded holes.
Mark all damaged areas requiring repair or replacement.
METAL LINES, FLEXIBLE HOSES, AND METAL FITTINGS
Inspect metal lines for sharp kinks, cracks, and bad dents.
Inspect flexible hoses for fraying, deterioration, evidence of leakage, and loose metal fittings or
connectors.
BUSHINGS
Inspect bushings for excessive wear, elongation, or grooving.
Section VII. ELECTRICAL SYSTEM
Page
Page
Composite Light . . . . . . . . . . . . . . . . . . . . . . . . . .4-18
4-18
Reach Tube Section Wire Harness . . . . . . . . . . 4-25
Rear Section Wire Harness. . . . . . . . . . . . . 4-29
Composite Light Lamp and Lens . . . . . . . . . . . . . . . 4-17
Wire Harness Repair. . . . . . . . . . . . . . . . . . . 4-19
Intervehicular Cable Receptacle . . . . . . . . . . . . . . . . 4-23