TM 9-2330-287-14&P
HYDRAULIC LINE REPLACEMENT - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
AXLE TEE TO LEFT SERVICE BRAKE - CONTINUED
Two clamps (2)
Remove.
Line (1)
17.
Discard line (1).
Two clamps (2)
Install.
New line(1)
18.
New line (1)
Place in position.
Axle tee (3) to
19.
connector (4)
Two screws (6) and
Using screwdriver, install.
Two clamps (2) to
20.
two Iockwashers (7)
axle (5)
Fitting (9)
Using 7/16-inch wrench, tighten.
Connector (4) to
21.
new line (1)
Fitting (10)
Using 7/16-inch wrench, tighten.
Axle tee (3) to
22.
new line (1)
AXLE TEE TO RIGHT SERVICE BRAKE
Fitting (12)
Using 7/16-inch wrench, loosen.
23. Axle tee (3) to
Iine (11)
Fitting (14)
Using 7/16-inch wrench, loosen.
24. Connector (13) to
line (11)
Line(n)
Remove.
25. Axle tee (3) to
Discard line (11).
connector (13)
New line(n)
Place in position.
26.
Fitting (14)
Using 7/16-inch wrench, tighten.
27. Connector (13) to
new line (11)
Using 7/16-inch wrench, tighten.
Fitting (12)
28. Axle tee (3) to
new line (11)
WHEEL CYLINDERS TO CONNECTOR
NOTE
This procedure is typical for the upper and lower wheel cylinder lines.
