TM 9-2330-294-14
(3) Place wood block approximately 6 in. x 8 in.
(5) Lubricate second tire bead and wheel flange
with rubber soap water.
that is 5 to 5-3/8 in. high under low side of tire for
support and to aline tire bead with groove in wheel
(6) Insert stop end of tire iron (T46B) and fla
rim.
end of iron (T48A) between tire bead and wheel
(4) Apply rubber soap water to tire bead and
flange 10 to 12 inches apart. Insert tire iron (T45)
wheel flange. Use a wood 2 x 4 Mock about one foot
between other tire irons.
long and hammer first bead around and under flange
(7) Push down on all three tire irons and for
(B, fig. 4-70). Make sure that tire bead at starting
second tire bead over rim flange (A, fig. 4-71).
point goes into groove in wheel rim during this
operation.