TM 9-2330-297-14&P
LICENSE PLATE LIGHT
This task covers:
INITIAL SETUP
Tools
Screwdriver, flat-tip
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1. License plate
Retaining ring (1),
a. Using screwdriver, pry off retaining
light
lens (2), gasket
ring (1).
(3), screws (6)
b. Remove lens (2) and gasket (3).
and light base (7)
c. Pull terminal (4) from harness
connector (5).
d. Using screwdriver, remove two screws
(6) and light base (7).
INSTALLATION
2.
Light base (7),
a. Position light base (7) on chassis
screws (6), gasket
frame.
(3), lens (2) and
b Using screwdriver, install two
retaining ring (1)
screws (6).
c. Push terminal (4) into harness
connector (5).
d. Place gasket (3) and lens (2) on
light base (7).
e. Snap retaining ring (1) into groove of
light base (7).
4-25
