TM 9-2330-297-14&P
CLEANING INSTRUCTIONS - CONTINUED
NOTE
Wash electrical cables and flexible hose with water and soap solution, and wipe dry. Oil seals are generally
damaged during removal. Cleaning will not be necessary because new seals will be used on assembly.
Refer to TM 9214 for instructions and procedures covering care and maintenance of antifriction bearings.
INSPECTION INSTRUCTIONS
All components and parts must be carefully checked to determine if:
1. They are serviceable for reuse.
2. They can be repaired.
3. They must be scrapped.
DRILLED AND TAPPED (THREADED) HOLES
Inspect for wear, distortion, cracks, or any other damage in or around holes
Inspect threaded areas for wear, distortion (stretched), or evidence of cross-threading.
Mark all damaged areas for repair or replacement.
METAL LINES, FLEXIBLE LINES (HOSES), AND METAL FITTINGS
Inspect metal lines for sharp kinks, cracks, bad bends, or bad dents.
Inspect flexible lines for fraying, evidence of leakage, or loose metal fittings or connectors.
Inspect gear teeth for wear, chips, or breakage.
Inspect gear shafts for wear or grooving.
BUSHINGS
Inspect bushings for excessive wear, elongation, or grooving.
4-20