TM 9-2330-297-14&P
BRAKE CHAMBER - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY
7.
Brake chamber
Housings (1) and
a. Place spring retainer (5) on rod (4).
(2), new diaphragm
b. Place spring (6) and rod (4) so that
(3), rod (4), spring
large end rests against spring re-
retainer (5) and
tainer (5).
spring (6)
c. Slide rod (4) through housing (2).
d. Position diaphragm (3) in housing (1).
e. Using vise, compress housing halves (1)
and (2) together.
8.
Two housing clamps
Using two 518-inch open-end wrenches,
(7), capscrew (8),
assemble parts.
lockwasher (9) and
nut (10)
9.
Jamnut (11) and
Install on rod (4).
Do not tighten.
clevis yoke (12)
INSTALLATION
10.
Axle
Brake chamber (13)
a. Place brake chamber (13) on mounting
bracket (14).
b. Using 13/16-inch open-end wrench, in-
stall washers (15) and nuts (16)
11.
Airhose (17)
Install airhose (17)using 3/4- and 7/8-inch
open-end wrenches.
NOTE
The brake chamber will be connected to the slack adjuster during the adjustment procedure.
4-70
