TM 9-2330-356-14
(19) Shut off engine (para 2-10d), then remove the
(10) Adjust engine throttle for desired flow rate
grounding wire.
WARNING
WARNING
When filling tank by means of self-loading, a
Hose reel cabinet door Is heavy-use two
test of the precheck system Is mandatory. If
hands when opening and closing. Use
this system Is not functioning, stop all
latches to lock door. Do not slam.
operations. Determine the problem and have
It corrected by a qualified technician. Failure
(20) Close hose reel cabinet door and latch in
of automatic shut-off to function may result in
place,
uncontrolled fuel spillage and danger of fire
and explosion.
(21) Store and cover fire extinguishers.
(11) Squeeze and hold lever on deadman control
b.
Filtered Bulk Delivery. This operation is used when
S. Shortly after flow has begun, turn precheck valve D to
filtered fuel is required in the storage facility (fig. 2-35).
the OPEN position to check the automatic shut-off float.
Fuel is pumped from the semitrailer tank through the
If float is functional, flow should stop after about
filter/separator to the storage facility. Filtered bulk
20-25 seconds (para 2-11g). If valve is not functioning,
delivery operation is as follows:
stop all operations. Notify unit maintenance.
(1) Review instructions in paragraph 2-8.
(12) Turn precheck valve D to the CLOSED
position. Free flow will resume in about 20 seconds.
(2) Ensure that all valves are closed.
(3) Connect grounding wire to storage facility
CAUTION
and semitrailer (fig. 2-7). Remove 4-inch bulk fuel hose
from hose trough and connect to the receiving facility.
In an emergency, release the deadman
Remove dust cap from outlet B and connect bulk fuel hose
control S and flow should stop.
to outlet.
(4) Start engine (para 2-10) and when warm
(13) When tank is full, flow should stop
adjust engine speed to 1000-1200 rpm.
automatically.
(5) Open valves A (para 2-11f), B, H, M, and K.
(14) At end of operation, release the deadman
control S, and adjust engine to idle speed
(6) Adjust engine throttle for desired flow rate
(1000-1200 rpm). Rewind the deadman control hose.
(15) Close single point nozzle and disconnect
(7) At end of operation, adjust engine to idle
nozzle from bottom load adapter. Reinstall dust caps on
speed (1000-1200 rpm).
bottom load adapter and single point nozzle.
(8) Close all valves.
(16) Evacuate hose (para 2-14d).
(17) Rewind 2-inch hose (para 2-11). Tighten
(9) Remove bulk fuel hose and store in hose
troughs. Secure hose trough latches. Reinstall dust cap to
hose reel lock.
outlet B. Remove grounding wire.
(18) Close all valves and remove 4-inch bulk fuel
hose connecting semitrailer to storage facility. Store hose
(10) Shut off engine (para 2-10d).
in hose trough. Secure hose trough latches. Reinstall dust
(11) Store and cover fire extinguishers.
cap to outlet B.
