TM 9-2330-356-14
Table 5-2. Fabricated Tools and Equipment (Con`t).
Sketch or Diagram:
Bulk Tubing Dia.
Part No.
Bulk Part No.
1/4"
60"
11670916-1
CPR 104420-1
60"
3/8"
11670916-2
CPR 104420-2
40"
11670916-3
8360440
5/8"
Section II. DIRECT SUPPORT AND GENERAL SUPPORT TROUBLESHOOTING
5-5.
Use
General
a.
Information in this section is for use by direct
This
a.
troubleshooting
contains
section
support and general support personnel.
information for locating and correcting most of the
troubles which may develop in the semitrailers. Each
b.
malfunction for an individual component, unit, or system
with and as a supplement to Operator Troubleshooting
is followed by a list of tests or inspections which will help
you to determine corrective actions to take. You should
elsewhere in this manual.
perform the test/inspections and corrective actions in the
Procedures and Instructions
5-6.
order listed.
NOTE
This manual cannot list all malfunctions that may
b.
occur, nor all tests and inspections and corrective actions.
Before you use the troubleshooting tables,
If a malfunction is not listed or is not corrected by listed
ensure that you have performed all applicable
corrective actions, notify your supervisor.
operational checks.
Ensure that all safety precautions listed in the
c.
a.
Warning Summary are followed while performing
on-equipment tests and inspections, and for testing the
component or assembly after it has been removed from
troubleshooting. Pay close attention to all WARNINGS
the semitrailer.
and CAUTIONS.
