TM 9-2330-357-14&P
4-48. OUTRIGGER REPLACEMENT (Con't).
b. CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear
protective goggles and gloves, and use only In a well-ventilated area.
Avoid contact with skin, eyes, and clothes, and DO NOT breathe vapors.
DO NOT use near open flame or excessive heat. The solvent's flash
point is 100 -138 (38 -59 ). If you become dizzy while using
F
F
C
C
cleaning solvent, Immediately get fresh air and medical help. If solvent
contacts eyes, Immediately wash your eyes and get medical aid.
1. Remove all buildup of grease or dirt using a clean rag or medium bristle brush and dry cleaning solvent, and
allow to dry.
2. Inspect for loose, missing, or damaged hardware.
3. Inspect for cracks, holes, warps, dents, and bends.
4. Visually check for mounting holes that are out-of-round or burred.
5. Inspect for rust, corrosion, or marred finish.
c. INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Lifting device Is
required when parts weigh over 50 lb (23 kg) for a single person lift, over
100 lb (45 kg) for a two person lift, and over 150 lb (68 kg) for a three or
more person lift. Keep clear of heavy parts supported only by lifting
device. Failure to follow this warning may cause serious Injury or death
to personnel.
1. Install bearing (23) in upright brace (9).
2. Attach suitable hoist to upright brace (9) and place into position on shoe (24).
3. Install pin (25), two spacers (20), feltwashers (22), and retaining rings (21).
4. Secure upright brace (9) by installing pin (26) in pin (25).
5. Attach suitable hoist to walkway frame (8) and place into position on outrigger lower bracket (17).
6. Install two pins (18) and four retaining rings (16) into outrigger lower bracket (17).
7. Install upright brace (9) to walkway frame (8) with pin (15) and two retaining rings (19).
4-101/
