TM 9-2330-357-14&P
4-50. OUTRIGGER DRIVE MOTOR REPLACEMENT (Con't).
b. REMOVAL
1. Disconnect outrigger motor cable from connector (1).
2. Remove four self-locking screws (6) and gently tap outrigger drive motor (2) to unseat it from gear housing
(4). Discard self-locking screws.
3. Remove spline connector (5) from outrigger drive motor (2).
4. Remove and discard gasket (3).
c. INSTALLATION
1. Align holes in new gasket (3) and outrigger drive motor (2). Install gasket to outrigger drive motor.
2. Install short end of spline connector (5) into outrigger drive motor (2) on shaft.
3. Install outrigger drive motor (2) on gear housing (4) with four new self-locking screws (6).
4. Connect outrigger motor cable to connector (1).
FOLLOW-ON TASKS:
Cycle outrigger with replaced drive motor through complete lowering and raising procedure to check operation
4-105
