TM9-2330-358-14&P
WARNING
Wear welding mask, gloves, and apron when welding or
using cutting torch. Failure to wear adequate
protective clothing may result in serious injury.
(2) Weld s-hook (2) to nose box (1) using arc welder. Refer to TM 9-237.
(3) Repeat steps 1 and 2 for other dummy coupling as needed.
TASK ENDS HERE
4-33.
AIR LINES
This task covers:
Remova1
Installation
INITIAL SETUP
Materials/Parts
Tools
Lockwire (item 17,
General mechanics tool kit
Equipment Condition
Drain cocks open (para. 3-8)
Removal.
a.
(1) Short air lines.
(a) Disconnect both ends of air line and remove.
(2) Long air lines.
(a) Disconnect both ends of air line.
(b) Tie a length of lockwire (1, fig. 4-30) to one end.
Do not remove
(c) Pull the air line (2) and lockwire (1) out of frame.
lockwire as it is needed to install air lines.
b. Installation.
(1) Short air lines.
(a) Connect both ends.
4-58
