TM9-2330-358-14&P
If turning causes drum to exceed original diameter by
more than 0.080 inch (2.032 mm), replace drum. The
other drum on that axle should be replaced also.
Check drum diameter after each cut to make sure you
have not cut too much metal out.
f. To refinish inner braking surface (2), mount brake drum on refinishing lathe.
Make several thin cuts until scoring has been removed.
g. Refinish other drum on that axle to the same specifications.
Assemble hub and drum and install on axle (para. 4-47).
h.
i.
Install tire and wheel assemblies (para. 4-45).
TASK ENDS HERE
SECTION v.
MAINTENANCE OF THE FRAME
Page
Frame . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-13
Kingpin.....
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
q
5-7. FRAME
Refer to TB 9-2300-247-40 for repair of the frame.
TASK ENDS HERE
5-8 .
KINGPIN
This task covers:
Removal
Installation
INITIAL SETUP
Tools
300 amp arc welder
General mechanics tool kit and common supplement
II
Personnel Required
TWO
5-13
