TM9-2330-368-14 & P
b. Installation.
4-28. SPARE TIRE CARRIER (cont)
(1) Hold landing gear (5) in upside down
b. Installation.
vertical position and place it so channel
(7) is alined with collar on trailer frame.
(1) Mount pawl plate (13) on main mem-
ber (10) with three cap screws (15) and
(2) Rotate landing gear (5) on frame to
lock nuts (14).
normal horizontal or vertical position.
Install pin assembly (6) to secure.
(2) Slide shaft (8) through pawl plate (13)
and main member (10). Install two flat
NOTE
washers (12) and cotter pin (11).
Insure landing gear is cranked all
the way up and plunger is in
(3) Feed ends of cable (7) through holes
second lowest hole.
(9) in shaft (8) so free lengths are equal.
(3) Install crank (4) and cap screw (3),
(4) With each half of cable (7) on same side
flat washers (2) and lock nut (1).
of shaft (8), rotate shaft several turns
to wrap cable on shaft.
NOTE
Do not over tighten nut (1).
(5) Insert free ends of cable (7) into outer
most holes in pickup member (6) and
bend each end inward approximately
3 inches.
(6) Install clamps (5), lock washers (4) and
nuts (3) on pickup member (6) so both
ends of cable (7) are secured by each
clamp. Tighten nuts (3) on clamps to
10 lb- ft.
(7) Install spare tire (para. 2-18b).
4-29. LANDING GEAR
Materials/Tools
General mechanics tool kit
a. Removal.
(1) Remove lock nut (1), flat washers (2),
TA252196
cap screw (3) and crank (4) from land-
ing gear (5).
(2) Remove pin assembly (6).
(3) Rotate landing gear (5) to the upside
down vertical position so channel (7)
disengages collar on trailer frame.
(4) Remove landing gear.
4-49
