TM 9-2330-371-14&P
This task covers:
a. Removal (page 4-141)
b. Installation (page 4-142)
INITIAL SETUP
Tools
Personnel Required
Extension, socket, 3/8-inch drive
One
Handle, socket, 3/8-inch drive
Screwdriver, cross-tip
Socket, 3/8-inch, 3/8-inch drive
Wrench, 3/8-inch, open-end
ACTION
ITEM
LOCATION
REMARKS
REMOVAL
NOTE
There are 10 reflectors on the semitrailer. This
procedure is for one. Repeat the procedure for the
others.
If reflector has wire harness clips mounted on the
back, do steps 1, 2, 7, and 8.
Nut (2) and
Screw (1)
1.
Using wrench, unscrew and take off.
Iockwasher (3)
Wire harness
a.
2.
Take off and mark location.
clip (4)
b.
Spread apart and take off wires.
