TM9-2330-372-14&P
TABLE 3-1. OPERATOR TROUBLESHOOTING TABLE-continued
Malfunction
Test or Inspection
Corrective Action
a. If composite light assembly terminal is loose, dirty, or corroded, clean and reconnect.
b. If composite light assembly terminal is clean and intact, proceed to Step 3.
Step 3.
Check composite light assembly for defect or damage.
a. If composite light assembly is defective, or damaged, notify organizational maintenance.
b. If light assemblies are intact proceed to Step 4.
Step 4.
Check intervehicular cable connector for dirty or corroded pins.
a. If cable connector pins are dirty or corroded, clean connector pins (para. 3-6).
b. If any of the above steps fail to correct the malfunction, notify organizational maintenance.
HAND BRAKE SYSTEM
4. HAND BRAKES WILL NOT HOLD TRAILER.
Check hand brake cable for too much slack.
a. Take up slack in cable by rotating knob on end of lever in clockwise direction.
b. If hand brake still fails to hold trailer, notify organizational maintenance.
5. HAND BRAKES WILL NOT FULLY RELEASE.
Check brake lever or slack adjuster on axle for defects or damage.
If defects or damage is visible on lever or assembly on axle, notify organizational maintenance.
3-7