TM9-2330-372-14&P
c. Repair. Replace all damaged axles.
d. Installation. Install (para. 5-6d).
5-8. SPRINGS.
5-8.1. XM1034 only.
a. Removal (Fig. 19).
NOTE
This procedure is for replacing one spring.
(1) Remove bogie (para. 5-6)
(2) Block trunnion bar (23) and detach spring (7) from the trunnion bracket (13) by removing the eight nuts (4
and 5), four retaining bolts (15) and the top plate (6).
(3) Detach spring from the shackle boxes on each axle by removing hex nuts (2 and 3), "U" bolts (16), cover
retaining nuts (1 and 26) shackle box covers (25), and top spacers (18).
WARNING
Each spring weighs approximately 100 pounds. Two persons are required to lift.
(4) Lift spring (7) from shackle boxes. Remove side spacers (8) and bottom spacers (17).
b. Installation.
NOTE
If shackle box spacers are worn or damaged install new spacers.
(1) Install spring in reverse of procedure a.
CAUTION
Do not torque trunnion bracket bolts (15) more than 175 lb-ft as it may damage the top plate (6).
(2) Torque trunnion bracket bolts to 150-175 lb-ft.
(3) Torque "U" bolt nuts (3) to 85-105 lb-ft.
(4) Install bogie assembly (para. 5-6e).
Change 1 5-5
