TM9-2330-372-14&P
(9) Install bearing cone (33), narrow end up.
(10) Raise outer housing (6) slightly above end of jack screw (2) and install cover assembly (29) with lube fitting
(31) toward pinion shaft. Secure with four socket head cap screws (34).
4-32. REPLACING TOOL BOX LOCK (Fig. 21).
a. Remove retaining clip (12), nuts (9), washers (11), latch (10), washer (8) and washer (7).
b. Pull out handle (2) and shaft (4) and remove spring (6) and washer (5).
c. Remove pin (3).
d. Replace damaged parts.
e. Assemble in reverse order.
4-33. REPLACEMENT OF REFLECTORS (Fig. 22).
a. Using flat tip screw driver remove two screws (3) and amber reflector (2) or red reflector (1) from trailer frame.
b. Install new reflector (1 or 2) and two screws (3).
NOTE
Red reflectors are at rear of trailer and amber reflectors are at the front of the trailer.
4-34. REPLACEMENT OF DATA PLATES (Fig. 23).
a. Remove drive screws (2) and plate (1), (3) or (4).
b. Install new data plate and drive screws (2).
4-35. PAINTING INSTRUCTIONS. General instructions are contained in TM 43-0139, Painting Instructions for Field
Use.
4-27/(4-28 blank)
