TM 9-2330-373-14 & P
4-38. DOORS (cont).
INSTALLATION OF HANDLE LOCK ASSEMBLY SIDE
DOOR/PARTITION DOOR
1. Position handle lock assembly (9).
2. Secure handle lock assembly with four bolts (6),
washers (7) and nuts (8).
INSTALLATION OF INTERIOR HANDLE, SIDE
DOOR/PARTITION DOOR
1. Position upper end of center locking rod (5) and
lower end of upper locking rod (4) with interior
handle (3) on handle lock assembly (9).
2. Secure handle and rods with two shoulder
screws (1) and spacers (2).
1.
Screw
4. Upper locking rod
7. Washer
2.
Spacer
5. Center locking rod
8. Nut
3.
Handle
6. Bolt
9. Handle lock assembly
INSTALLATION OF EXTERIOR HANDLE
1. Position spacer (6), inner preformed packing (3)
and escutcheon plate (5) if they had been
removed. Secure with three rivets (4).
2. Position exterior handle (2) and outer preformed
packing (3).
NOTE
Screw (1) must be coated with lock-tite prior
to installation. Over-torque of this screw will
cause fracture of interior shear pin.
3. Apply lock-tite to threads of screw (1). Secure
handle (2) with screw (1) to a torque of 3-4 lb-ft
(4.07-5.42 Nm).
1.
Screw
2.
Handle
4.
Rivet
3.
Preformed packing
5.
Escutcheon plate
6.
Spacer
TA 314843
4-123
