TM 9-2330-376-14&P
5 - 1 . BOGIE ASSEMBLY REPLACEMENT (Con't).
WARNING
Never crawl under equipment when performing maintenance unless equipment is
securely blocked. Keep clear of equipment when It is being raised or lowered. Do not
allow heavy components to swing while suspended from lifting device. Exercise
extreme caution when working near a cable or chain under tension. Failure to follow this
warning could result in severe injury or death to personnel.
Use overhead hoist to raise trailer to clear bogie assembly.
8.
Raise rear leveling jacks to stowed position (para 2-13).
9.
Push or pull bogie assembly out from under rear of trailer.
10.
Lower rear leveling jacks (para 2-13). Lower overhead hoist enough to rest trailer on leveling jacks. Remove
11.
lifting sling from each lifting eye (para 2-1 5).
INSTALLATION
b.
WARNING
Never crawl under equipment when performing maintenance unless equipment is
securely blocked. Keep clear of equipment when it is being raised or lowered. Do not
allow heavy components to swing while suspended from lifting device. Exercise
extreme caution when working near a cable or chain under tension. Failure to follow this
warning could result in severe injury or death to personnel.
Prepare trailer for lifting (para 2-15), Use overhead hoist to raise trailer off leveling jacks.
1.
Raise rear leveling jacks to stowed position (para 2-13).
2.
Use overhead hoist to raise trailer to allow
3.
sufficient clearance for bogie assembly.
Push or pull bogie assembly under trailer and
4.
lower trailer onto bogie assembly.
Lower rear leveling jacks (para 2-13).
5.
Lower trailer frame until trunnion axle brackets
6.
seat on trunnion axle (16).
7.
On one side of trailer, install clamp (14) with four
screws (15), new lockwashers (1 3), and nuts (1 2).
Torque nuts to 85-105 Ib.-ft. (115-142 Nm).
Repeat for other side of trailer.
Remove lifting sling from each lifting eye (para
8.
TA701010
5-4
