TM 9-2330-376-14&P
5 - 2 . FRONT AND REAR AXLE REPLACEMENT.
This Task Covers:
a.
b.
Installation
Removal
Initial Setup:
Equipment
Conditions:
Tools/Test Equipment:
Bogie assembly removed (para 5-1).
General mechanic's tool kit
Wheels chocked on each end of axle not being
Floor jack
removed (para 4-17).
Two jackstands
Personnel Required: Two
REMOVAL
a.
1.
Place a jackstand under each spring assembly (2)
between trunnion axle (1) and axle (3) to be
removed.
2.
Place a floor jack under axle (3) to be removed.
Remove service brakes and backing plates from
3.
axle (3) to be removed (para 4-29).
4.
Remove hydraulic hose, tubes, and fittings from
axle (3) (para 4-34).
WARNING
Ensure that spring assembly is supported before removing axle. Spring assembil
will fall without support. Failure to follow this warning may result in serious injury to
personnel.
Axle is heavy and awkward to handle. Use caution, provide adequate support, and
use assistance when removing. Failure to follow this warning may result in serious
injury or death.
Disconnect spring assembly (2) from each end of axle (3) (para 5-6).
5.
Lower and remove axle (3).
6.
TA701013
5-7
