TM 9-2330-381-14
(6) Once support leg foot (5) is near stow position, with lowest hole in inner leg near retaining pin hole in outer leg
housing (6), aline holes and install retaining pin (2). Rotate pin to lock in place and install linch pin (1).
(7) Repeat steps (4) thru (6) of this procedure to raise other front support leg.
(8) Lower platform (para. 2-19) to travel height of approximately 43 inches (109 cm).
(9) If no other adjustments are required, push in suspension shut-off valve handle (para. 2-6) as far as possible to
SHUT-OFF position.
d. If any material was used to provide ground support for front support legs, remove and stow or dispose of material.
Change 2 2-69