TM 9-2330-381-14
KEY
EXPECTED TEMPERATURES
+40 to
0F to
ABOVE
+32F
-10F
-50F
CAPACITY
INTERVALS
GAA
GREASE, AUTO-
M - Monthly
(MIL-G-10924)
MOTIVE AND
ALL TEMPERATURES
ARTILLERY
Snatch Block
As req
Cylinder
Bearing
As req
SFL
SOLID FILM
LUBRICANT
ALL TEMPERATURES
Ramp Pivot
Pin
As req
9.
SNATCH BLOCK. Monthly lubricate snatch block. Scrape off any existing grease and dirt that may have built up.
Clean surfaces using rags. Clean surrounding areas and fittings. DO NOT OVERFILL. Lubricate sheave pin at grease
fitting on bottom side of snatch block. Hand apply generous portions of grease (GAA) to all moving parts on the snatch
block and contact areas and wipe off excess with rag.
10.
SPRING GUIDE ROD. Monthly lubricate ramp spring guide rods. Remove guide rod and spring assembly from
ramp. Scrape off any existing grease and dirt that may have built up. Clean surfaces using rags. Spray generous
portions of solid film lubricant (SFL) on spring rod and rod contact surfaces and wipe off excess with rag.
11.
RAMP PIVOT PIN. Monthly lubricate ramp pivot pins. Scrape off any existing grease and dirt that may have built
up. Clean surfaces using rags. Clean surrounding areas. Spray generous portions of solid film lubricant (SFL) to ramp
pivot pin surfaces and wipe off excess with rag.
Change 1 3-9
