TM 9-2330-381-14
4-22.
GOOSENECK COMPONENT ASSEMBLY (CONT)
REMOVAL
NOTE
Pull gooseneck component assembly out of gooseneck approximately 3 inches
(7.6 cm) and twist component assembly 180 degrees. Place component assembly
partially back into gooseneck with terminal boards exposed so that the W1
harness can be disconnected.
1.
Remove six screws (1) and lockwashers (2) and slide gooseneck component assembly (3) out of gooseneck (4).
Reinsert component assembly (3) upside down into gooseneck. Discard lockwashers.
2.
Remove locknut (5) and clamp (6) from W1 harness (7) and gooseneck component assembly (3). Discard
locknut.
3.
Using semitrailer electrical schematic (figure FO-1) as a guide, tag and disconnect W1 harness from B side of
terminal boards TB1 (8) and TB2 (9).
4.
Remove gooseneck component assembly (3) from gooseneck (4).
DISASSEMBLY
1.
Remove four locknuts (1) and screws (2) and lift fixed resistor R2 (3) off of gooseneck component assembly (4).
Discard locknuts.
4-94
